- Online Training
- New Content
Submitted by James Klim DDS, CADStar Host on 08/27/2012 - 10:11pm
Submitted by James Klim DDS, CADStar Host on 08/27/2012 - 10:07pm
Submitted by James Klim DDS, CADStar Host on 08/24/2012 - 12:21pm
Submitted by James Klim DDS, CADStar Host on 08/24/2012 - 12:17pm
The historical recommnended 19 min 50 sec e.max speed crystallization fire time is the one that I have been using. There has been a shorter one being pushed that is under 13 min.
The research conclusion of the under 13 min protocol is now being documented. Two primary issues, less than full crystallization shift from the metasilicate to the disilicate leading to more opaque ceramic and rougher surface finish. Will this be a significant ceramic
Submitted by James Klim DDS, CADStar Host on 08/19/2012 - 4:47pm
This video tutorial will review my two Omnicam impression techniques. Having been a beta tester for the Omnicam, this camera is opically error proof. As long as the data is complete over the preparation and adjacent contact zones, it will fit! One important point, the Bluecam AC will provide equally as good virtual information and milled restorations as the Omnicam. I am still using both systems.
Submitted by James Klim DDS, CADStar Host on 08/18/2012 - 11:08pm
The steps for CEREC 4.0 virtual design is the same for the Omnicam virtual model as the CEREC AC Bluecam model. However, the colored virtual die doe add more flavor to the process. View Video Posted in CEREC Liftoff Chapter 9.
Submitted by James Klim DDS, CADStar Host on 08/18/2012 - 10:19pm
Submitted by James Klim DDS, CADStar Host on 07/21/2012 - 10:50pm
I often receive questions about managing e.max proximal contacts from the virtual design through the crystallization stage and prevent proximal contact opening. This tutorial will review the three step I take to assure ideal and predictable e.max proximal contacts. Video tutorial posted in CEREC Liftoff Chapter 6...view
Submitted by James Klim DDS, CADStar Host on 06/20/2012 - 1:40pm
Submitted by James Klim DDS, CADStar Host on 05/17/2012 - 11:55am
Hi fellow CEREC colleagues...4.0.3 is working very well and have found that I have gone back to my 3.85 parameters for inlay/onlay. Best inlays margins I have ever seen with CEREC!!!!....even with the step S bur…Wow!
These parameter metrics are my current start position for 4.0.3. Inlay/Onlay Parameters.
Jazzed!